Stephen Kalipetsis

  • Total activity 45
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 24

Activity overview

Latest activity by Stephen Kalipetsis
  • Stephen Kalipetsis created an article,

    iOS VSSL App Release Notes

    1/21/2025 iOS v1.3.0  Google Cast 2.0 Certified for enhanced streaming and performance Dramatic reduction (50% or more) in setup time for SX Series devices (Depending on your network configuration...

  • Stephen Kalipetsis created an article,

    A Series End of Support

    VSSL Announces End of Support for the A Series Product Line 8 years After Introduction   Hurricane, UT - October 7, 2024: VSSL, a global provider of premium audio streaming devices, announces the e...

  • Stephen Kalipetsis created an article,

    SX Series Set Up & Configuration

    App Compatibility  The SX products are only compatible with the new VSSL app. The VSSL Legacy does not support the SX Series, only VSSL amplifiers.                                                P...

  • Stephen Kalipetsis created an article,

    AirPlay Set Up (X Series)

    The X Series Amplifiers are certified as AirPlay 2-Enabled receivers. Each VSSL zone works with the Home App on iOS, iPadOS, and macOS.  Using AirPlay gives listeners these abilities:  Group zon...

  • Stephen Kalipetsis created an article,

    Google Home Set Up (X Series)

    VSSL's X Series amplifiers are Google-Certified with Chromecast built-in!  When paired with a Google Nest or Home devices with Google Assistant, you can initiate and control audio to any zone using...

  • Stephen Kalipetsis created an article,

    The A.1x Is Not Joining A Group of AirPlay 2 Devices In A Party Zone

    The A.1x will need to be updated to AirPlay 2. Using the VSSL app, check the firmware version and call into Tech Support

  • Stephen Kalipetsis created an article,

    My VSSL Device Is Outputting A Strange Digital Tone, What Is Wrong?

    We typically see this with the A.1x and A.3x when using digital inputs. The optical and digital inputs only accept PCM audio and not the surround encoded signals like Dolby or DTS. You can correct ...

  • Stephen Kalipetsis created an article,

    I Am Having Difficulty Setting Up The Zones On The A.1x, A.3x, and A.6x

    1. Verify that the zone light(s) flash white. If they are, the unit is ready to be set up.    2. Second, check to make sure the device you are using to set up the VSSL are on the same local area ne...

  • Stephen Kalipetsis created an article,

    I Am Unable To Control The Volume Properly On The A.1x

    Check to see if you are using the pre-amp outputs. If you are, you need to verify that the "Fixed Output" setting is disabled. Go to the VSSL app -> Settings -> Select your A.1x -> Bus Output -> To...

  • Stephen Kalipetsis created an article,

    How Do I Keep My Zones From Dropping? (A.1x, A.3x, A.6x)

    This is almost always a network issue. The key is to understand your network to avoid going in circles.    1. First, we always recommend using name brand, well known, commonly used networking equip...